la config de grbl:
$0=19 (step pulse, usec)
$1=255 (step idle delay, msec)
$2=0 (step port invert mask:00000000)
$3=4 (dir port invert mask:00000100)
$4=0 (step enable invert, bool)
$5=0 (limit pins invert, bool)
$6=0 (probe pin invert, bool)
$10=18 (status report mask:00010010)
$11=0.010 (junction deviation, mm)
$12=0.002 (arc tolerance, mm)
$13=0 (report inches, bool)
$20=0 (soft limits, bool)
$21=0 (hard limits, bool)
$22=1 (homing cycle, bool)
$23=2 (homing dir invert mask:00000010)
$24=25.000 (homing feed, mm/min)
$25=500.000 (homing seek, mm/min)
$26=250 (homing debounce, msec)
$27=1.000 (homing pull-off, mm)
$100=512.000 (x, step/mm)
$101=512.000 (y, step/mm)
$102=512.000 (z, step/mm)
$110=300.000 (x max rate, mm/min)
$111=300.000 (y max rate, mm/min)
$112=300.000 (z max rate, mm/min)
$120=15.000 (x accel, mm/sec^2)
$121=15.000 (y accel, mm/sec^2)
$122=15.000 (z accel, mm/sec^2)
$130=250.000 (x max travel, mm)
$131=146.000 (y max travel, mm)
$132=120.000 (z max travel, mm)