Salut, en te lisans je pense a un probleme de configuration de fin de course, utiliser en no ou nf, je me suis pris la tete avec ça pour ma anet a8, j'arrivais pas a bouger mes moteurs
l y a du nouveau
j'ai enfin réussi à me connecter avec Pronterface il fallait que je passe en 250000 en 115200 çà ne passait pas d'ailleurs maintenant çà passe également avec Repetier Host
donc j'ai envoyé la commande m119 sur Pronterface et voilà le résultat :
avec la config suivante :
// Mechanical endstop with COM to ground and NC to Signal uses "false" here (most common setup).
#define X_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
#define Y_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
#define Z_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
#define X_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
#define Y_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
#define Z_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
#define Z_MIN_PROBE_ENDSTOP_INVERTING false // Set to true to invert the logic of the probe.
status
x_min: TRIGGERED
y_min: TRIGGERED
z_min: TRIGGERED
donc je change false en true
// Mechanical endstop with COM to ground and NC to Signal uses "false" here (most common setup).
#define X_MIN_ENDSTOP_INVERTING true // Set to true to invert the logic of the endstop.
#define Y_MIN_ENDSTOP_INVERTING true // Set to true to invert the logic of the endstop.
#define Z_MIN_ENDSTOP_INVERTING true // Set to true to invert the logic of the endstop.
#define X_MAX_ENDSTOP_INVERTING true // Set to true to invert the logic of the endstop.
#define Y_MAX_ENDSTOP_INVERTING true // Set to true to invert the logic of the endstop.
#define Z_MAX_ENDSTOP_INVERTING true // Set to true to invert the logic of the endstop.
#define Z_MIN_PROBE_ENDSTOP_INVERTING true // Set to true to invert the logic of the probe
status
x_min: open
y_min: open
z_min: open
donc je lance un auto home les 3 axes bougent un peu et s'arretent et un message d'erreur s'affiche sur l'écran :
HOMING FAILED
PRINTER HALTED
PLEASE RESET