@Fred69
bonsoir Fred
voila qui est fais suppression et installation de la version 0.92.4 de Inkscape.
je viens de reproduire le carré de Julien Leresteux.
apparemment ça a marché j'ai bien retrouver mon fichier a l’emplacement que j’ai désigné.
Le fichier a été nome
carre_001 et non carre_ngc comme tu me la précisé un peu plus haut .
Ai-je tous bon a par l’extension
_001 du fichier, (cela pose t'il problème)?.
merci
Mon carré de 100 x 100mm
Ci-dessous le listing de ce fichier
(Header)
(Generated by gcodetools from Inkscape.)
(Using default header. To add your own header create file "header" in the output dir.)
M3
(Header end.)
G21 (All units in mm)
(Start cutting path id: rect3723)
(Change tool to Default tool)
G00 Z4.000000
G00 X0.000000 Y100.000003
G01 Z-1.000000 F100.0(Penetrate)
G01 X99.999997 Y100.000003 Z-1.000000 F400.000000
G01 X99.999997 Y0.000000 Z-1.000000
G01 X0.000000 Y0.000000 Z-1.000000
G01 X0.000000 Y100.000003 Z-1.000000
G00 Z4.000000
(End cutting path id: rect3723)
(Footer)
M5
G00 X0.0000 Y0.0000
M2
(Using default footer. To add your own footer create file "footer" in the output dir.)
(end)
%
ci dessous le listing de Julien Leresteux
%
(Header)
(Generated by gcodetools from Inkscape.)
(Using default header. To add your own header create file "header" in the output dir.)
M3
(Header end.)
G21 (All units in mm)
(Start cutting path id: rect2985)
(Change tool to Default tool)
G00 Z5.000000
G00 X-0.040318 Y120.508894
G01 Z-1.000000 F100.0(Penetrate)
G01 X141.070792 Y120.508894 Z-1.000000 F400.000000
G01 X141.070792 Y-0.040313 Z-1.000000
G01 X-0.040318 Y-0.040313 Z-1.000000
G01 X-0.040318 Y120.508894 Z-1.000000
G00 Z5.000000
(End cutting path id: rect2985)
(Start cutting path id: rect2985)
(Change tool to Default tool)
G00 Z5.000000
G00 X-0.040318 Y120.508894
G01 Z-2.000000 F100.0(Penetrate)
G01 X141.070792 Y120.508894 Z-2.000000 F400.000000
G01 X141.070792 Y-0.040313 Z-2.000000
G01 X-0.040318 Y-0.040313 Z-2.000000
G01 X-0.040318 Y120.508894 Z-2.000000
G00 Z5.000000
(End cutting path id: rect2985)
Ce sont les commandes en GCode pour dessiner le carré.
Notez que le même dessin est répété 4 fois mais avec une profondeur (valeur de Z) qui augmente à chaque passe. Notre fraise et le moteur se portent mieux ainsi !